Infrared Obstacle Avoidance IR Sensor Module (Active Low) Subtotal: ₹30.00
-20%
Electronic modules
10K Ohm 3Pin 15mm Shaft Potentiometer
Availability:
50 in stock
- Resistance: 10k Ω.
- Tolerance: 20%.
- Shaft Length: 15mm.
₹32.00 ₹40.00
50 in stock
CompareIt is a 10K Ohm 3Pin15mm Shaft Potentiometer. This is used for adjusting various parameters like voltage, current, etc in an electronic circuit.
Based on 0 reviews
Be the first to review “10K Ohm 3Pin 15mm Shaft Potentiometer”
Related products
-
Accessories, Arduino Supported Boards, Electronic modules, Raspberry Pi Boards
3.7V to 12V Mini DC-DC Boost Step Up Converter Board Module 5V/ 8V/ 9V 12V Output
-20%
Accessories, Arduino Supported Boards, Electronic modules, Raspberry Pi Boards3.7V to 12V Mini DC-DC Boost Step Up Converter Board Module 5V/ 8V/ 9V 12V Output
- Input Voltage:2.5V~VOUT-0.5V
- Output Voltage: can be set to 5V/8V/9V/12V
- The maximum output current reaches 1A.
- Low power consumption.
- The LED indicator can be turned off by the pad next to it.
SKU: n/a -
Accessories, Arduino Supported Boards, Drivers, Electronic modules, Raspberry Pi Boards
ULN2003A Driver Module Stepper Motor Driver
-9%
Accessories, Arduino Supported Boards, Drivers, Electronic modules, Raspberry Pi BoardsULN2003A Driver Module Stepper Motor Driver
- 5-12V power supply
- 4-way signal indicator
- Chip all the pins have Input leads Mounted for easy connection to use
- XH-5P socket can be connected directly 28BYJ-48 Model stepper motor
- Dimensions: 32 x 18 x 11mm (LxWxH)
- Weight: 3 gm
SKU: n/a -
Accessories, Arduino Supported Boards, Electronic modules, Raspberry Pi Boards
TP4056 Adjustable 1A Li-ion lithium Battery Charging Module with Overcurrent Protection – Type C Port or 5V DC Point for Input power, Output : 4.5-5.5V, Full charge voltage: 4.2V
-33%
Accessories, Arduino Supported Boards, Electronic modules, Raspberry Pi BoardsTP4056 Adjustable 1A Li-ion lithium Battery Charging Module with Overcurrent Protection – Type C Port or 5V DC Point for Input power, Output : 4.5-5.5V, Full charge voltage: 4.2V
- Input interface: Type C
- Current Protection: Yes
- Charging mode: Linear charging.
- Current: 1A adjustable.
- Charge precision: 1.5%.
- Input voltage: 4.5V-5.5V.
- Full charge voltage: 4.2V.
SKU: n/a -
Electronic modules
ESP-WROOM-32 WIFI Bluetooth Networking Smart Component Development Board
Item Type: Bluetooth Module, Development Board Based On: ESP32 Based, WROOM Type Flash Memory (MB): 4MB Processor Two Low-Power Xtensa 32-bit LX6 Microprocessors Operating Voltage (VDC): 3.0V – 3.6V Operating Current (mA): 80 Clock Frequency (MHz) 80 to 240 Data Rate (Mbps) 150 SRAM Memory (KB) 520 Length (mm): 50 Width (mm): 28 Height (mm): 14 Weight (g): 10 Shipping Weight 0.015 kg Shipping Dimensions 6 × 8 × 2 cm SKU: n/a
There are no reviews yet.